I made some more progress on my R32 Skyline suspension, and the wheel bearings in particular. After some experimentation I was able to get the bearings pressed out of the housings with my 12-Ton press. I now have both the front and rear hubs completely naked… no bearings, bushings, etc. I’ll sand blast the outsides, clean up the insides, paint, and then it is time to install new stuff.

I was able to find a US source for both front and rear wheel bearings, including the clips, seals, and even the king pin setup, so once that arrives it will be reassembly time.

It appears that these hubs had not been disassembled before, at least based on the bearing marks. Even though these bearings were 25 years old, they looked to be in great condition. I just wanted to replace them to be sure.