Getting the wrist pins out in an H6 with the wide Pauter rods is turning out to be a real pain. Since there are 3 cylinders/side, there is a very small margin of space in a stock motor where you can use a long screwdriver to push out the wrist pin from the other side. [ Unlike in an EJ, there are two rods in the way instead of one ]

With the wider then stock Pauter rods there is no room at all. The only way to get the pin out is to pull it. I used a blind puller on one side which worked, and that enabled me to get the other two on that side.

The blind puller isn’t long enough for the other side ( the distance from the case to the pin is a bit longer).

I guess it is time to fab something up.